TT:stopActivity

This article contains information that is only valid for a future railML® version. The article refers to version 2.4, whereas the current railML® version is 2.5. 2.5

{{elementDocu |elementName=stopActivity |parent=<stopActivities> |childs=None |semantics=The element describes the activity carried out at this stop. (introduced with version 2.4) |ownAttributes=

• type: describes the activity carried out at this stop. Possible Values are:

• collect: Couple vehicles / train parts - intended for non-self-propelling train parts. Please consider relation to formations (as far as used) Zu- und/oder Absetzen von Fahrzeugen bzw. Zugteilen

– vorgesehen für nicht selbstfahrende Zugteile. Zusammenhang zur konkreten Formation beachten (sofern verwendet)

• drop:Uncouple vehicles / train parts - intended for non-self-propelling train parts. Please consider relation to formations (as far as used)
• split:Uncouple vehicles / train parts - intended for self-propelling train parts. Please consider relation to formations (as far as used)
• join: Couple vehicles / train parts - intended for self-propelling train parts. Please consider relation to formations (as far as used)
• shunting: Shunting movements are planned during stop (may also be used additionally to collect/drop/split/join/staple on demand)
• crewChange: Stop to change engine or train crew
• crewBreak: Stop for engine or train crew to pause
• reverse: Stop to change driving direction of train. Consider relation to @formationReversed
• runAround: Shunting of the engine to the other end of train (normally during change of driving direction). Normally combined with reverse
• engineAttach: Receiving of pilot/pushing/double-heading engines - no train coupling
• engineDetach: Dropping of pilot/pushing/double-heading engines - no train splitting
• engineChange: Change of engine (no train coupling and sharing / splitting)
• staple: Notes the necessity of staple track(s) during the stop time
• occupation: Stop caused by occupation of lines, tracks, blocks incl. crossing without further specification
• occupationBlock: Stop caused by occupation of route by another train running ahead
• occupationCrossing: Stop caused by occupation of route by an oncoming train
• occupationStation: Stop caused by occupation of station track(s)
• powerSystemChange: Stop caused by a change of power supply (e.g. to change pantograph)
• vehicleInspection: Stop for technical / technological vehicle inspections
• gaugeChange: Stop caused by a change of gauge (e.g. to change or convert axles)
• authorityCheck: Stop for purposes of passport or customs check or other authorities
• photo:
• catering: Supply or disposal of passengers or payload, e. g. catering
• supplyOrDisposal: Supply of vehicles with operating supplies or materials or disposal of waste, including taking water for steam traction or steam heating
• movementAuthority: Stop to receive the permission to proceed into the next route section
• releaseLine: Stop to release the permission to proceed from the previous route section
• shuntingPermission: Receive and/or release the permission to shunt inside ocp during stop time
• misc: Specification possible by using @purpose
• other:anything: Any value that does not fit any value from the previous enumeration list, fulfilling the constraint: at minimum two characters, whitespace is not allowed. Please, apply Dev:usingAny accordingly.

• xs:anyAttribute: This provides an extension point for non-railML^® attributes in a foreign namespace. How to use it?