RS:gangway

From railML 2 Wiki
Revision as of 14:42, 20 December 2010 by RailML Coord Rollingstock (talk | contribs) (new attributes)
Jump to navigation Jump to search


gangway
 


Scheme description / Schemenbeschreibung

Position of gangway in the XML-Tree / Position von gangway im XML-Baum

  • Parent: passenger
  • Children: Not yet described. / Noch nicht beschrieben.

Multiplicity / Anzahl

[1..1]

Semantics / Bedeutung

The element <gangway> contains all data for gangways alowing the interchange to neighbouring vehicles.

Das Element <gangway> beinhaltet alle Daten für die Beschreibung von Wagenübergängen, die von Personen während der Fahrt genutzt werden können.

Attributes of gangway / Attribute von gangway

  • frontEnd: This is the flag, whether there is a gangway on the front end of the vehicle.
  • rearEnd: This is the flag, whether there is a gangway on the rear end of the vehicle.
  • position: This specifies the position of the gangway, assuming the same position for both ends.
  • standardUIC - position according UIC standard
  • upperDeck - position for interchange at upper deck level
  • lowerDeck - position for interchange at lower deck level
  • other - any other position
  • designType (> 2.0): selection of possible design types, shall be same type for both sides or only one gangway at all
  • standardUIC561 - The standard UIC gangway of the well-known rubber type.
  • special - A special design type of gangway.
  • nonPublic - A gangway which can be used by staff but not the public.
  • unknown - Unspecified design type of gangway.
  • other - Any other design type of gangway.
  • floorLevel (> 2.0): The height of the gangway's floor above top of rail in millimetres.
  • gangwayHeight (> 2.0): The (inner) height of the gangway for passenger use in millimetres.
  • gangwayWidth (> 2.0): The (inner) width of gangway for passenger use in millimetres. If the width differs over height the smallest value shall be given here.

Syntactic Constraints / Syntaktische Beschränkungen

The attributes frontEnd, rearEnd and designType are mandatory when the element <gangway> is used. However, the element can be used several times for any vehicle.

Best practice & Examples / Empfohlene Anwendung & Beispiele

Not yet described. / Noch nicht beschrieben.

Notes / Anmerkungen

The description of gangway position can be very roughly by attribute position or with detailed dimensions. In latter case the attribute position shall not be used.

Open issues / Offene Punkte/Pendenzen

Not yet described. / Noch nicht beschrieben.